10-Pack 433MHz DC12V 10A Wireless Relay RF Remote Control Switch Receiver Module

Product Specifications:

• Input Voltage: DC 10-14V
• RF Frequency: 433 MHz
• RF Working Mode: Super heterodyne receiver
• Receiver Sensitivity: >90 dBm
• Remote Control Distance: >100 meters (in open environment)
• Decoding Method: MCU Software decoding
• Remote Control Capacity: 50
• Supported Remote Control Types: Fixed code, learning code
• Channel: 1CH
• Multiple Working Modes: Jog/Non-Latched, Inter-lock/Latched, Self-lock/Self-Latched, Delay off
• Wiring Method: Fixed wiring terminal
• Working Voltage: DC 12V
• Output Current: 10A
• Rated Load: 10A 250VAC / 10A 125VAC 10A 30VDC / 10A 28VDC
• Output: Normally open, Common, Normally closed
• Dimensions: 3.5 cm x 3 cm x 1.6 cm

Working Mode Instructions:

1. Jog: Press and release the learning button. The system will automatically switch to action mode. Wait until the LED turns off, indicating entry into learning mode. Press the remote control button; the LED will flash five times before turning off. After a 3-second delay, the LED will illuminate, indicating successful learning, and the system will exit learning mode.
2. Self-locking: Press and release the learning button twice to set the system to self-locking mode. Wait until the LED turns off, signaling entry into learning mode. Press the remote control button; the LED will flash five times and then turn off. After a 3-second delay, the learning is successful.
3. Interlock: Press the learning button and release it three times in succession to set the system to interlock mode.
4. Delay: Press the remote control to activate the relay. Release the remote control to begin timing; after 5, 10, or 15 seconds, the relay will automatically close.

Additional Features:

• Press the learning code button, wait for the indicator to flash, then release your finger. Press any button on the remote control, and the indicator will flash twice and turn off, indicating successful learning.
• Supports learning up to 12 remote controls using 2262 or 1527 chips with different codes at 433 MHz.
• To remove all learned remote control information, press and hold the learning button for about 8 seconds. The indicator will turn on and then off, confirming all stored information has been successfully removed.

Package Includes:

• 10 x 12V 1CH 433MHz Wireless Relay Switch Receiver